Remove/Install The Oil Temperature Indicator - Diamond DA20-C1 Maintenance Manual

Maintenance Practices
9.

Remove/Install the Oil Temperature Indicator

A. Remove the Oil Temperature Indicator
1. Disconnect the aircraft battery.
2. Remove the engine cowlings.
3. Disconnect the two electrical connectors from
the rear of the oil temperature indicator.
4. Remove the locking ring from the oil
temperature indicator.
5. Remove the oil temperature indicator from the
instrument panel into the cockpit.
B. Install the Oil Temperature Indicator
1. Position the oil temperature indicator into the
instrument panel from the cockpit.
2. Install the oil temperature indicator:
- Put the locking ring onto the oil
temperature indicator.
- Turn the locking ring clockwise until the oil
temperature indicator is tight in position.
3. Connect the electrical connector to the oil
temperature indicator.
4. Install the instrument panel cover.
5. Do an engine run up test. Look especially for
correct oil temperature indications.
Page 210
14 Jan 13
Detail Steps/Work Items
Detail Steps/Work Items
79-00-00
Key Items/References
Refer to Chapter 24-31-00.
Refer to Chapter 71-10-00.
Hold the oil temperature indicator while you
remove the locking ring.
Key Items/References
Make sure that the oil temperature indicator
is positioned correctly before you attach the
locking ring.
Refer to Chapter 25-10-00.
Refer to the Continental Motors IO-240
Series Engine and Overhaul Manual,
Publication M-6 for oil temperature data.
For the engine run procedure, refer to the
DA20-C1 Airplane Flight Manual.
DA20-C1 AMM
DA201-C1
Rev 21