Diamond DA20-C1 Maintenance Manual page 134

Maintenance Practices
B. Install the Flap
1. Put the flap in position on the aircraft.
2. Install the pivot bolts in the hinges and the flap
horn.
3. Install the bolt which attaches the control rod to
the flap horn.
4. Install the bushing.
5. Do a test for correct adjustment of the flaps.
6. Do an inspection of the flap controls which you
disconnected or adjusted.
7. If necessary for your airworthiness authority,
do a second inspection of the flap controls.
Page 202
09 May 11
Detail Steps/Work Items
57-50-00
Key Items/References
Hold the flap.
Hold the flap. Make sure that there is a gap
of 0.12 - 0.20 in (3 - 5 mm) between the flap
and the aileron.
Ream the bushing to Ø 9.525 (+0.010 and
+0.050) after installation to fit properly.
Refer to AMM Chapter 27-50.
DA20-C1 AMM
DA201-C1
Rev 18