Installing The Finger-Print Reader Board; Removing The Led Board - Dell Latitude E5550 Owner's Manual

Installing the Finger-Print Reader Board

1. Insert the finger-print reader board into its place on the palmrest.
2. Connect the finger-print reader cable to the finger-print reader board.
3. Place the metal bracket on the finger-print reader board and tighten the screw to secure the finger-
print reader board.
4. Install the:
a. keyboard trim
b. keyboard
c. palmrest
d. battery
e. base cover
5. Follow the procedures in

Removing the LED Board

1. Follow the procedures in
2. Remove the:
a. base cover
b. battery
c. keyboard trim
d. keyboard
e. palmrest
3. Perform the following steps to remove the LED board:
a. Disconnect the LED-board cable from its connector on the LED board [1] [2].
b. Remove the screw that secures the LED board to the palmrest [3].
c. Remove the LED board from the palmrest [4].
After Working Inside Your
Before Working Inside Your
Computer.
Computer.
21