Installing The Power-Switch Board; Removing The Smartcard Reader Board - Dell Latitude E5550 Owner's Manual

Installing the Power-Switch Board

1. Place the power-switch board to its slot on the palmrest.
2. Tighten the screws to secure the power-switch board to the palmrest.
3. Install the:
a. palmrest
b. keyboard
c. keyboard trim
d. battery
e. base cover
4. Follow the procedures in

Removing the SmartCard Reader Board

1. Follow the procedures in
2. Remove the:
a. base cover
b. battery
c. memory
d. keyboard trim
e. keyboard
f. palmrest
3. Perform the following steps:
a. Disconnect the SmartCard reader board cable from the USH board [1] [2].
b. Peel the cable to release from the adhesive [3].
After Working Inside Your
Before Working Inside Your
Computer.
Computer.
17