C.E.C. CD3N Owner's Manual page 6

Belt drive
Table of Contents

Advertisement

CD PLAYER CD3N
6
door and the CD-turntable on the CD3N.
❻ Installation
Use of an audio rack is recommended to maximize the sound quality and
performance of the CD3N. Installation and use of the CD3N in the locations
described below may cause deterioration in sound quality or malfunction:
● Locations exposed to direct sunlight, such as windowsills, and other
exceptionally warm locations, such as near heating appliances (surrounding
temperature higher than 35 °C), or exceptionally cold locations (surrounding
temperature lower than 10 °C), may prevent the CD3N from functioning
adequately.
● Damp locations exceeding 90% humidity may cause the CD3N's metal
parts to rust, causing the unit to malfunction.
● Dusty locations may cause the CD3N to malfunction. The accumulation
of dust inside the CD door may lower the performance of music signal
reading. It may also cause contact failure of the switches, and/or noise.
● Otherwise, avoid installing the CD3N close to other transformers and
electrical motors, so as to prevent the pickup of induction hum. Also, avoid
mounting the unit on surfaces that may be affected by vibration.
❼ Avoid lightning strikes
Disconnect the AC power cord from the AC outlet when there is a
thunderstorm in your vicinity.
❽ Condensation When the CD3N is brought into a warm room when the
exterior temperature is cold, or when the room temperature rises sharply
from using a heater, condensation may form both inside and outside the
unit, hampering its performance. If this happens, leave the CD3N unused
in the room for 1 to  hours (depending on the amount of condensation),
so as to bring the unit's temperature closer to the room temperature. The
condensation should go away gradually.
❾ Listening etiquette
When adjusting the sound volume level, make sure you do not disturb other
people and your neighborhood.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents