Reel Table (S) / Reel Table (T) Assembly - Sony DSR-PD170 Service Manual

2-2-4.

Reel Table (S) / Reel Table (T) Assembly

Remove the
"2-2-1. Tape Fall Stopper"
and "2-2-3. Damper Assembly and Cassette Compartment Assembly"
Removing method: Remove in the order of 1,2,3,4.
Attaching method: Attach in the order of 2,1,4,3.
After attaching all the parts, refer to the flowchart on page 6-51,
and perform the adjustments from Starting adjustments-1.
Details diagram on removal of
reel table (S) assembly
Does not disconnect.
The gear is engaged with the reel table, and
does not disconnect.
Pull the part with an object with a pointed
end to disengage.
Disconnects.
2-2-5. Cassette Base Block Assembly, Gooseneck Gear Assembly and Relay Gear
Remove the
"2-2-1. Tape Fall Stopper"
and "2-2-3. Damper Assembly and Cassette Compartment Assembly"
Removing method: Remove in the order of 1,2,3,
4,5,6.
Attaching method: Attach in the order of 6,5,4,
3,2,1.
Details diagram on removal and
attachment of LED
Removing : ,
Attaching : K
Fig.1
Be careful not to scratch the Flexible board.
Details diagram on State Checking
of Brake (S)
The gear is engaged with the reel table, and
does not disconnect.
Pull the part with an object with a pointed
end to disengage.
Fig.2
Reel table (S) assembly
(Take note of how it should be removed.)
When attaching the reel table, avoid the TG1
adjusting plate assembly.
(Be careful not to scratch the tension regulator pad.)
Refer to 2-2-12. for details on
how to replace assemblies such
as the brake S.
Cassette base block assembly
tightening torque
0.0686 N•m (0.7 kg•cm)
Brake (S)
3
4
Remove towards the front upwards.
Screw
3
2
State check
(Refer to figure-2)
Disconnects.
Apply the grease
Does not disconnect.
(1.5 mm dia.)
6-43
DSR-PD170/PD170P/PD190P
Screw tightening torque tolerance.
0.0098 N.m (0.1 kg.cm)
Use only new washers. Do not reuse
washers that have been removed once.
Stopper washer
Stopper washer
1
2
Reel table (T) assembly
Do not touch the external
circumference gear of the
reel table.
4
1 LED (Refer to figure-1)
3 Screw
3
Cassette base block
Screw
assembly
5
Gooseneck gear assembly
6
Relay gear
Claw
Claw