Installation Instructions - Regency L850B Owners & Installation

Montrose wood fireplace

Hide thumbs

Table Of Contents

Table of Contents

installation

UNIT PREPARATION/FRAMING/CLEAN EDGE AND FACEPLATE WALL FINISHING

BEFORE INSTALLING ENSURE THE FOLLOWING:

READ THE ENTIRE MANUAL

EVALUATE THE LOCATION OF YOUR FIREPLACE AND LOCA-

TION OF OPTIONAL COMPONENTS SUCH AS FAN, OUTSIDE

AIR AND FACEPLATE.

DETERMINE WHAT THE THICKNESS OF YOUR DESIRED NON-

COMBUSTIBLE FINISHING MATERIALS INCLUDING THE RE-

QUIRED NON-COMBUSTIBLE BOARD. THIS PREDETERMINED

THICKNESS WILL DICTATE THE CAVITY DEPTH, POSITION OF

THE NAILING FLANGES, FRAMING AND OVERALL FINAL LOOK

OF YOUR FIREPLACE.

The unit comes standard with nailing flanges and clean edge frame installed.

Clean edge frame: MAXIMUM THICKNESS OF FINISHING MATERIAL: 32MM

Optional Faceplate: MAXIMUM THICKNESS OF FINISHING MATERIAL:

32MM

1. Determine the location of the fireplace, flueing location and locations of the

options such as the Fan Kit and outside air. Determine if the fireplace will be

using the clean edge frame or faceplate.

2. Construct your base frame. Please see BASE FRAME instructions on page

11. The base frame is required TO RAISE THE UNIT in order to meet the

300mm clearance to the finished floor.

3 Position your base frame in the predetermined location of fireplace. Level

then mark the position of the base frame. Remove the frame and set aside.

4. Frame out back wall if required and side walls only of the fireplace cavity.

DO NOT FRAME FRONT WALL. The back and side walls of the cavity can

be constructed using timber. Please refer to page 9 and 10 for clearances

and cavity depth.

5. Reinstall the base frame and secure to the floor.

6. If using optional outside air kit please refer to page 23. The optional air kit

adapter must be installed must be installed prior to the unit being positioned

on to the base frame

7. Install the fireplace on the base frame. Secure unit to the base frame