Panasonic KX-TD308 Summary Manual page 110

A
Conditions
• In Verified - All Calls mode, you must always enter a pre-assigned account code when
making any of the following calls unless it has previously been stored in memory.
a) Call Forwarding — to Outside Line
b) Manual Dialing (Selecting an outside line)
c) Pickup Dialing (Hot Line)
d) Redial, Last Number
e) Station Speed Dialing
f) System Speed Dialing
• In Option mode, it is possible to record a calling or called party's account code in the
SMDR.
• It is not possible to enter an account code during a conversation or while hearing a
reorder tone.
• Pressing " " while entering an account code allows you to clear the number and re-enter.
• Flashing the hookswitch while entering an account code cancels the entry.
• An account code can be up to ten numeric digits (0 through 9). After entering an
account code, the delimiter "#" or "99" must be entered (the entered account code
should not be "99" or end with "9").
• An account code can be stored into Memory Dialing ("Pickup Dialing (Hot Line)",
"System/Station Speed Dialing", "Call Forwarding — to Outside Line"). The sequence
to enter an account code into Memory Dialing is as follows:
— [Feature Number] [Account Code] [#] [Line Access Code] [Phone Number]
— [Feature Number] [Account Code] [99] [Line Access Code] [Phone Number]
• If an entered account code does not match a stored account code when making an
outside call, a reorder tone is returned.
• If you use an account code which is for a private call, the phone number of the
destination is not recorded on SMDR.
Programming References
• System Programming — Installation Manual
[105] Account Codes
[508] Account Code Entry Mode
[601] Class of Service
Feature References
Station Message Detail Recording (SMDR)
Toll Restriction Override by Account Code Entry
* Class of Service (COS) is used to define the features which are allowed for a group of extensions.
For more details, please consult with your dealer.
5-10
Standard Telephone Features
5.2 Standard Telephone Features
or
(→ see Installation Manual)