Troubleshooting - Panasonic KX-TD308 Summary Manual

7

Troubleshooting

If a power failure should occur...
Your system enables conversations between specific outside lines and extensions (Power
Failure Transfer), and supports system data backup.
Power Failure Transfer
Specific extensions are automatically connected directly to specific outside lines. This
provides outside line conversations between the following extensions and outside lines:
Outside line 1 is connected to extension jack number 1.
• All other conversations are disconnected during a power failure.
• Digital proprietary telephones (DPT) cannot be used during a power failure. Standard
telephones can work in the event of a power failure. Connect them to the above jacks.
• When power is restored after a power failure, your system automatically restarts
operation, maintaining as much of the previous system data as possible.
Problem
Nothing is heard in the
handsfree mode.
The unit does not ring.
The display flashes the
following message:
Set Time & Date
WED JAN01 12:00A
7-14
Appendix
Appendix
Probable Cause
The "Headset" mode is
selected.
• The outside line number
is not programmed.
• The Ringer Volume is set
to "OFF".
The system internal clock
does not work properly.
Possible Solution
When the headset is not used,
set the mode to "Handset".
Refer to "Handset/Headset
Selection" in Station
Programming (Section 2), or
"Initial Setting" (Section 1.1).
• For programming outside line
numbers, please consult with
your dealer.
• Increase the Ringer Volume.
Refer to "Initial Setting"
(Section 1.1).
Consult with an authorized
Panasonic Factory Service
Center.