Epson EMP-7850 User Manual page 38

Turning the Projector On
If more than one external device is connected to the
5
projector, use the remote control or projector control
panel buttons to select the image source to be
projected while referring to the following table.
You can also use the preview function to select the signal
source. p.38
Remote control
Button to press
Port
Remote
control
EasyMP [EasyMP]
*1
[ ]
Computer Comp
DVI [DVI]
*1
[ ]
BNC BNC
[ ]
S-Video S-Video
[ ]
Video
Video
On-screen display
Projector
EasyMP
The image
source changes Computer
*3
each time (Analog-RGB)
[Computer/ Computer
*3
DVI] is (RGB-Video)
*2
pressed.
DVI
BNC(Analog-RGB)
The image
BNC(RGB-Video)
source changes
*5
BNC(YCbCr )
each time
*5
BNC(YPbPr )
[Video/BNC] is
*4
S-Video
pressed.
Video
*1 When these buttons are pressed once, the signal name that is currently
set using the configuration menus appears on the screen. You can
change the signal setting by repeatedly pressing the button while the
signal name is displayed. The result of this switching will also be
applied to the "Computer Input" or "BNC Input" setting in the "Setting"
menu.
*2 The input signal will not change to the next signal source unless the
[Computer/DVI] button is pressed while the current signal name is still
being displayed on the screen.
If an input signal from either the [DVI] or [Computer] port is currently
being projected, the name of this current input signal will be displayed
on the screen when the [Computer/DVI] button is pressed once.
*3 The item selected using the "Computer Input" command in the
"Setting" menu will appear. You can change the setting by pressing the
[Comp] button on the remote control.
*4 The input signal will not change to the next signal unless the [Video/
BNC] button is pressed while the current signal name is still being
displayed on the screen.
If an input signal from either of the [BNC], [S-Video] or [Video] ports
is currently being displayed, the name of this current input signal will
be displayed on the screen when the [Video/BNC] button is pressed
once.
*5 The item selected using the "BNC Input" command in the "Setting"
menu will appear. You can change the source to the next source in order
by pressing the [BNC] button on the remote control.
When using EasyMP, change the image source to
6
*5
EasyMP. Refer to the EasyMP Setup Guide after
*5
changing.
EMP-7850 User's Guide
37