Epson EMP-7850 User Manual page 109

Problem Solving Problem Solving
Check
Has a critical problem developed causing the
projector to momentarily stop working?
Is power being supplied to the projector?
The projector cannot be monitored and controlled using the EMP Monitor function.
Check
Is the projector computer correctly connected
to the network?
Are the settings for connecting to a network
correct ?
Has EMP Monitor function been correctly
installed to the computer?
Have all projectors that are to be monitored
and controlled been registered in the
projector list?
Has "Standby Mode" been set to "Network
ON"?
Is power being supplied to the projector?
When the projector has momentarily stopped working, it cannot send e-mail messages. If the
projector cannot be reset even after it has been checked, contact your dealer or the nearest address
provided in the "International Warranty Conditions" section of the Safety Instructions/World-Wide
Warranty Terms booklet.
Check if the power supply to the location where the projector is set up has been interrupted, or if the
circuit breaker for the electrical outlet that the projector is connected to has been tripped.
Check that the network cable is properly connected. If the cable is not connected, or is incorrectly
connected, please connect it properly.
Check the Network advanced settings.
Connection Mode" in the EasyMP Setup Guide
Uninstall EMP Monitor and then re-install it.
EasyMP Software" in the EasyMP Setup Guide
Register the projector in the projector list.
EasyMP Operation Guide
If using the EMP Monitor function while the projector is in standby mode, change the "Standby
Mode" menu setting to "Network ON".
Check if the power supply to the location where the projector is set up has been interrupted, or if the
circuit breaker for the electrical outlet that the projector is connected to has been tripped.
Remedy
Remedy
p.18
"Connecting in Access Point Mode or Wired LAN
"Installing EasyMP Software" and "Uninstalling
"Monitoring and Control Using EMP Monitor"
"Advanced1" - "Standby Mode"
EMP-7850 User's Guide
108
in the
p.88