Configuration Settings - Harris ZX2500 Technical Manual

ZX Series
!
CAUTION:
INCORRECT SETTINGS COULD CAUSE A LOSS OF BOARD CONNECTIVITY.
CAREFULLY READ TABLE A.5.1 TO UNDERSTAND THE IMPLICATIONS OF
CHANGING EACH PARAMETER.
STEP 7
STEP 8
STEP 9
Table A-3 List of settings on configuration page.
TX NAME
IP ADDRESS
SUBNET MASK
DEFAULT
GATEWAY
SET MINUTE,
HOUR, DAY,
MONTH, YEAR
SEC/DAY
EMAIL ENABLED
SMTP SERVER
TO: ADDRESS
FROM: ADDRESS
LINK ADDRESS
12/20/11
WARNING: Disconnect primary power prior to servicing.
Toggle "E-MAIL Enabled" button off-on to send a test e-mail message,
as desired.
Toggle "SNMP Trap Enabled" button off-on to send a test trap, as
desired.
Procedure complete.

CONFIGURATION SETTINGS

The identification name for the transmitter. Since this name also doubles as the
NETBIOS name for the web remote, it is limited to 15 characters and cannot con-
tain spaces.
The IP address of the web remote. A change of this setting could cause a loss of
board connectivity.
The subnet mask of the web remote. A change of this setting could cause a loss of
board connectivity.
The IP address of the PC/router/device through which the web remote sees the rest
of the LAN/Internet. A change of this setting could cause a loss of board connec-
tivity.
A means to set the current log for the on-board clock used to time stamp log
entries.
NOTE: the MINUTE button will also reset the seconds to 00 when pressed.
The number of seconds added to /subtracted from the clock each day. A means to
fine trim the clock speed. See section A.5.5 for an adjustment procedure.
Activates the e-mail notification in case of an RF < ALARM THRESHOLD con-
dition. Toggling this setting from 0(off) to 1(on) will cause a test email to be sent.
The IP address of the SMTP server responsible for forwarding the e-mail notifica-
tion.
The target e-mail address for the e-mail notification.
A from: address to populate the e-mail notification address header. This can be a
fictitious address. It is required because some e-mail servers will reject a message
with this field left blank. The from: address can be used to identify the sending
transmitter. e.g. Harris_ZX@Mt_Alto_site.com
A link to the web remote main page appearing in the body on the e-mail notifica-
tion. If the full address is written (starting with http://...) the link should appear in
the received e-mail as fully "clickable", thereby allowing the recipient to easily
navigate to the main page, especially in small/mobile devices.
888-2595-001
Appendix A - FM Web Remote Option
A-15