Operation; Access Main Page - Harris ZX2500 Technical Manual

ZX Series
STEP 11
NOTE:
To access the web remote for the first time, there are two different options:
•
1:1 connection to PC: Use a crossover type cable, and the PC should have its
IP address manually set to 192.168.1.xx, where xx is 0-255, but not 99.
•
Connection to router: Some router types use a default address of
192.168.1.1. (e.g. LINKSYS) In such a case, the web remote may be
connected directly to the router via a straight (non-crossover) cable.
STEP 12
STEP 13
STEP 14
STEP 15
STEP 16
STEP 17
STEP 18
A.3

Operation

All monitoring, logging, and commands are on a single, straightforward, main web
page. Use this procedure to access the main page.
A.3.1

Access main page

STEP 1
STEP 2
STEP 3
12/20/11
WARNING: Disconnect primary power prior to servicing.
Attempt to access configuration page via procedure in section A.5.1.
Default password is "expert". Default IP address is 192.168.1.99 unless
otherwise indicated.
If web remote will not respond to IP address of 192.168.1.99, perform an
expert reset per procedure in section A.5.3.
On configuration page, set IP address to final desired address. Where
indicated, access router configuration page and set port 80 forwarding to
web remote IP address. Set other user parameters per information given
in Table A.5.1.
Access main page via procedure in section A.3.1.
Verify web remote properly commands and monitors transmitter.
Change configuration settings as desired until satisfied with all aspects
of web remote operation (passwords, SMTP, SNMP, etc).
Record all configuration settings on paper and store in safe place for
future reference. (passwords, addresses, etc)
Procedure complete.
Open web browser on PC.
Enter IP address of web remote (preceeded by http://) on address line
and press RETURN.
Empty page with "PASSWORD?" prompt should be displayed.
888-2595-001
Appendix A - FM Web Remote Option
A-5