Perform Simple Reset - Harris ZX2500 Technical Manual

ZX Series
Table A-3 List of settings on configuration page.
WRITE
COMMUNITY
VALID SET VALUE
SNMP TRAP
ENABLED
SNMP TRAP
ADDRESS
VERSION
A.5.2

Perform Simple Reset

Purpose: Issues simple reset of microprocessor. Essentially the same as cycling power
to card.
Special Tools: Small plastic screwdriver.
STEP 1
STEP 2
STEP 3
STEP 4
12/20/11
WARNING: Disconnect primary power prior to servicing.
The SNMP WRITE community for SET commands.
As an added security measure, the value "written" by the SNMP SET must match
this value. Otherwise, no command will be issued.
Enables alarm notification of an RF < ALARM THRESHOLD fault via a generic
SNMP trap. Toggling this setting from 0(off) to 1(on) will cause a test trap to be
sent.
The destination IP address of the trap notification.
The software version of the web remote.
Locate WEB RESET hole on I/O panel at upper rear face of amplifier
chassis. (See Figure A.6)
Press button continually with small plastic adjustment tool or similar
item for ten seconds. Maintain button depressed continually for full ten
seconds.
Web remote processor resets and will resume operation within seconds
of button release.
Procedure complete.
888-2595-001
Appendix A - FM Web Remote Option
A-17