Fitting And Lowering The Floor-Tool - Numatic TTB 4055 Owner's Instructions Manual

Fitting and lowering the Floor Tool
The floor-tool has been designed for quick fitting, allowing easy squeegee blade replacement and a safety knock-off
feature if the floor-tool gets snagged, whilst in transit.
Note:
It is easier to fit the floor-tool if the weight of the machine is resting on the brush. Ensure the brush is fitted first.
Filling the clean-water tank
The TTB 4055/100T is equipped with a 40 litre clean-water tank allowing large areas to be cleaning in a single fill.
Fig.26
The clear dump hose at the rear of the machine can be used to see the level of the clean water.
Note.
Great care must be taken to ensure that contaminants (leaves, hair, dirt, etc) are not allowed to enter the
clean-water tank during the filling process.
If using a bucket or similar, ensure it is always clean and free from debris.
Control of Substances Hazardous to Health (COSHH)
For best results use a non-foaming type of chemical, dilute to the manufacturers specification.
For further guidance on hazardous substances refer to health and safety instructions online.
Visit http://www.hse.gov.uk/
!
WHEN HANDLING AND MIXING CHEMICALS.
Always ensure that chemical manufacturer's safety guidelines are followed.
Only use chemicals recommended for use in auto scrubber-dryers.
Fit the floor-tool and retain using the
detent pin (Fig.23).
The lifting strap is also held by a
detent pin (Fig.24).
Fig.23
Raise the floor-tool for transit or
lower for cleaning operation using
the lifting handle fitted to the back of
the machine (Fig.25).
Fig.24
For fitting the floor-tool blades
(See Page 16).
Fig.25
To fill the clean-water tank, use the 1 meter FLEXI
- FILL pipe from either a tap or hose pipe (Fig.26).
The large cap can also be unscrewed for filling
from a bucket or suitable
container.
Fill the clean-water tank to a maximum of 40 litres,
including cleaning chemicals if required.
Follow chemical manufacturing guide lines.
for UK information.
11
Machine Set-Up
!