Lowering The Floor-Tool; Lowering The Brush Deck; Machine Operation - Numatic TTV 4555 Owner's Instructions Manual

Lowering the floor-tool

25
After preparing the floor (see previous section), we are now ready to set the controls to suit the cleaning conditions.
Before any settings can be applied, ensure the brush deck is lowered (see Fig.25).
Move the floor-tool lever to its lower position (see Fig.26).
Note: The machine will still reverse with the floor-tool in the lowered position,
this could possibly damage the blades. Raise the floor-tool before selecting reverse.

Lowering the brush deck

Note: If the brush width has not been set, see 'Setting the width adjustment' on page 9 before proceeding.
27
The control for lowering the brush deck can be found to the rear right of the machine (Fig.27).
Lower the brush deck by moving the left hand release lever to the upper position (see Fig.28).

Machine Operation

26
13
28