Before You Begin; Locking The Spray Gun; Pressure Relief Procedure; Grounding The Spray Gun - Titan XT250 Owner's Manual

Before you Begin -

Locking / unlocking the Spray Gun
Always lock the trigger off when attaching the spray
tip or when the spray gun is not in use.
Model XT-05
The gun is locked when the trigger lock is at a 90º angle
(perpendicular to the trigger in either direction).

Pressure Relief Procedure

Be sure to follow the Pressure Relief Procedure when shutting the unit off for
any purpose. This procedure is used to relieve pressure from the spray hose.
1. Lock the spray gun off (see
directions above). Flip the ON/
OFF switch to the OFF position.
Grounding the Spray Gun (oil-based materials only)
If spraying or cleaning with with oil-based materials, the
spray gun must be grounded while preparing the spray
hose or cleaning.
Ground the gun by holding it against the edge of a metal
container while purging. Failure to do so may lead to a
static electric discharge which may cause a fire.
Keep hands clear of the fluid stream.
This section contains instructions that
will be repeated throughout this manual.
Model LX60
To lock the gun, turn the trigger lock forward and slightly down
until it stops.
2. Turn the PRIME/SPRAY knob to
PRIME.
7
3. Unlock the spray gun and trigger
spray gun into the side of the
material bucket. Lock the spray
gun.
English