Assembly - Titan XT250 Owner's Manual

Do not plug in the power cord until assembly is complete.
If you have one of the cart models (XT290 or XT330) you will need to unfold the cart before using. Follow steps 1-3,
below. If you have the model XT250 sprayer, skip to item 4, below.
1. Grab the pail bracket to lift up the sprayer. Lift the leg
lock and unfold the legs. Move leg lock down to lock
into place (inset).
3. Lift the handle until the motor housing and handle locks
into place. Be careful not to pinch the power cord with
the cart.
5. Thread the other end of the hose to the spray gun. Hold
the gun with one adjustable wrench, and tighten the
hose nut with the other.
7. Press the return tube onto
the return tube fitting.
Squeeze clip over the
return tube fitting to secure
the return tube.
English

Assembly

The spray tip should not
be attached until after the
sprayer and spray hose have
been purged and primed.
2. Twist the knob on either side of the cart toward the "UP"
arrow until it stops.
4. Thread one end of the high pressure spray hose to
the spray hose port. Hold the port with an adjustable
wrench, and tighten the hose with the other.
6. Remove cap from inlet valve (a).
Thread the suction tube onto the
inlet valve and tighten firmly by
hand. Be sure that the threads
are straight so that the fitting
turns freely.
(a)
8. Verify that the seal is
present inside the suction
tube. Thread the inlet filter
into the end of the suction
tube.
6