Table of Contents
Advertisement
INSTALLATION
Continued
Note: All vertical
measurements
are from top
of fireplace
opening to
bottom of
mantel shelf.
Minimum Non-
Combustible
Material
Figure 8 - Minimum Mantel Clearances
for Built-In Installation
REMOVING BRICK LINER
RETAINER
1. Using Phillips screw driver, remove 2 screws
attaching brick liner retainers to vertical
sides.
2. Remove brick liner retainers and discard.
Replace 2 screws into vertical sides.
ASSEMBLING TRIM
(Trim shipped with mantel)
1. Remove packaging from three pieces of
trim.
2. Locate two adjusting plates with set screws
and two shims in the hardware packet.
3. Align shim under adjusting plate as shown in
Figure 9.
4. Slide one end of adjusting plate/shim in slot
on mitered edge of top trim (see Figure 9).
5. Slide other end of adjusting plate/shim in slot
on mitered edge of side trim (see Figure 9).
6. While firmly holding edges of trim together,
tighten both set screws on the adjusting plate
with slotted screwdriver.
7. Repeat steps 1 through 6 for other corner.
8. Set trim assembly aside for later installation.
113897-01E
Mantel Shelf
10"
8"
6"
2
1
/
"
2
www.desatech.com
Slot
Set Screws
Shim
Adjusting
Plate
Slot
Figure 9 - Assembling Trim
OPTIONAL MANTEL INSTALLATION
Note: Refer to instructions provided with the man-
tel for assembly instructions. Refer to instructions
below for system installation. If using blower ac-
cessory (see Accessories, page 34), see installation
instructions on pages 12 through 15.
1. Choose location for fireplace and install gas
supply line.
2. Remove screen from fireplace by removing
screws in each end of screen rod (see Figure
10). Hold screen rod cover while removing
five hex head screws underneath hood (see
Figure 11). Carefully lift and pull out hood
(see Figure 12, page 12).
Figure 10 - Removing Screen
Screw
Figure 11 - Removing Hood Screws
Top
Trim
Mitered
Edge
Side
Trim
Hood
Screen Rod
Cover
11
Advertisement
Table of Contents
