Comfort Glow CF26PRA Owner's Operation And Installation Manual page 19

INSTALLATION
Continued
4. Install remote receiver unit onto gas log heater
base using clips (2) and insulating washers
provided.
5. Push clips firmly into place (see Figure 29).
6. Connect wires as shown in Figure 30.
Front Front
Mounting
Clips
Insulating Washers
Figure 29 - Installing Remote Receiver
Valve
White Wire
From Receiver
Figure 30 - Connecting Wires
INSTALLING WIRELESS REMOTE
CONTROL ACCESSORY
Two 9-volt alkaline batteries (not included) are
required to operate this heater with the wireless
hand held remote control set. One battery must
be installed in the receiver and one in the hand-
held remote control unit. Note: Only use alkaline
batteries.
Installing 9-Volt Battery in Receiver
1. Locate back of receiver under front burner of
heater.
2. Locate the battery clip mounted on the back
of the receiver.
3. Slide a 9-volt battery through the clip.
4. Attach the terminal wires to the battery.
113897-01E
Back
Back
Remote
Receiver
Red Wire From
Receiver
www.desatech.com
9-Volt
Battery
Figure 31 - Installing Receiver on the
Back of the Base
Installing 9-Volt Battery (Not Included) in
Hand-Held Remote Control Unit
1. Remove battery cover on back of remote
control unit.
2. Attach terminal wires to the battery. Place
battery into the battery housing.
3. Replace battery cover onto remote control
unit.
Battery
Cover
Terminal
Wires
Figure 32 - Installing Battery in Hand-Held
Remote Control Unit
Receiver
Terminal
Wires
Battery Clip
Remote
Control Unit
Battery
Housing
9-Volt Battery
19