Table of Contents
Advertisement
OPERATING FIREPLACE
Continued
10. Wait one minute and switch selector switch
to the ON position to light burner.
11. Set flame adjustment knob to any level
between HI and LO.
CAUTION: Do not try to ad-
just heating levels by using the
equipment shutoff valve.
WARNING: Make sure the
selector switch is in the OFF
position when you are away from
home for long periods of time.
Heater will come on automati-
cally with selector switch in the
ON position.
Pilot Burner
Propane/LP
Figure 34 - Pilot
TO TURN OFF GAS
TO APPLIANCE
Shutting Off Heater
1. Turn control knob clockwise
OFF position.
2a. Set selector switch in the OFF position
2b.
If Using Optional Hand-Held Remote:
selector switch in the OFF position to keep
from draining battery.
Shutting Off Burner Only (pilot stays lit)
You may shut off the burner and keep the pilot
lit by doing one of the following:
1. Turn control knob clockwise
PILOT position.
2. Use remote control manual OFF button.
3. Set selector switch in the OFF position.
113897-01E
Ignitor
Electrode
Pilot Burner
Natural Gas
www.desatech.com
1. Follow steps 1 through 6 under Lighting
Instructions, page 20.
2. Depress control knob and light pilot with
match.
3. Keep control knob pressed in for 30 seconds
after lighting pilot. After 30 seconds, release
control knob. Now follow steps 9 through
11 under Lighting Instructions, page 20.
OPTIONAL HAND-HELD
REMOTE OPERATION
Note: All remote control accessories must be
purchased separately (see Accessories, page
34). Follow instructions included with the
remote control.
NOTICE: You must light the pilot
before using the hand-held re-
mote control unit. See Lighting
Instructions on page 20.
After lighting, let pilot flame burn for about one
minute. Turn control knob to ON position. Adjust
flame adjustment knob anywhere between HI and
LO. Slide the selector switch to the REMOTE
position (see Figure 35). Note: The burner may
light if hand-held remote was on when selector
switch was last turned off. You can now turn the
burner on and off with the hand-held remote
control unit.
IMPORTANT: Do not leave the selector switch
in the REMOTE or ON position when the pilot
is not lit. This will drain the battery.
Flame
Adjustment Knob
to the
Set
Selector Switch in Remote Position
(Optional Remote Control)
Figure 35 - Setting the Selector Switch,
Control Knob and Flame Adjustment
to the
Knob for Remote Operation
MANUAL LIGHTING
PROCEDURE
ON
OFF
REMOTE
Control Knob
in On Position
1
Advertisement
Table of Contents
