Yamaha FZS6W Service Manual page 81

1. Clip
2. Roll over valve assembly
3. Canister hose
4. Balance hose
5. Clamp
6. Canister assembly
7. Upper bracket
8. Hose
9. Canister bracket
10.Fuel tank drain hose
11.Roll over valve hose
A. Front side
B. Point the paint marking upward.
C. Pass the canister hose outside, pass the
balance hose inside.
D. Point the knob of clamp front side. The
application of water is possible at the time
of attachment.
E. Point the knob of clamp upward. The appli-
cation of water is possible at the time of
attachment.
F. Pass the balance hose under the canister
hose.
G. Insert to the back, but the tip of the nipple
should not come out from the hose.
H. Point the knob of clamp downward.
I. Install the part pointing the white paint
mark to the front side of the vehicle. The
application of water is possible at the time
of attachment.
J. Clamp the fuel tank drain hose so that the
distance between the paint mark and the
edge of the clamp may become 430–440
mm (16.9–17.3 in).
2-58
CABLE ROUTING