Yamaha WR450F 2-TRAC Supplementary Owner's Service Manual page 15

∂ Pass the carburetor breather
hose (throttle cable cover)
through the hose holder.
´ Fasten the coolant reservoir
tank breather hose and carbure-
tor breather hoses together with
a plastic locking tie.
ƒ Fasten the grommet of the
clutch cable with the cable hold-
er.
CABLE ROUTING DIAGRAM
© Fasten the rectifier/regulator
lead to the frame with a plastic
locking tie and cut off the tie
end.
˙ Fasten the CDI unit lead to the
frame with a plastic locking tie
ends at the lower of the frame
and cut off the tie end.
ˆ Insert the CDI unit band over
the CDI unit stay (frame) as far
as possible.
13
SPEC
∆ Fasten the starter motor lead
and negative battery lead to the
cable bracket in its slot with a
plastic locking tie and cut off the
tie end.
˚ Do not allow the rectifier/regula-
tor lead to slacken.
¬ Fasten the clamp so that the
point of closing is found inside
the protection of transmission
hoses.