Cable Routing Diagram - Yamaha WR450F 2-TRAC Supplementary Owner's Service Manual

CABLE ROUTING DIAGRAM

1
Fuel tank breather hose
2
Clamp
3
Diode
4
Wire harness
5
Hot starter cable
6
Negative battery lead
7
Starter motor lead
8
TPS (throttle position sensor) lead
9
Neutral switch lead
0
Oil hose
q
Hose holder
w
Radiator hose 4
e
Cylinder head breather hose
r
AC magneto lead
t
Radiator hose 1
CABLE ROUTING DIAGRAM
y
Oil tank breather hose
u
Brake hose
i
Hose guide
o
Carburetor breather hose
t
Overflow hose
a
Coolant reservoir tank breather
å Insert the fuel tank breather
hose into the hole in the steer-
ing shaft cap.
∫ Fasten the diode of the wire
harness and rectifier/regulator
lead (at its protecting tube) to
the frame at the white tape for
the diode with a plastic locking
tie and cut off the tie end.
9
SPEC
ç Fasten the wire harness, rectifi-
er/regulator lead, coolant reser-
voir hose and hot starter cable
to the frame with a plastic lock-
ing tie and cut off the tie end.
∂ Fasten the wire harness, rectifi-
er/regulator lead and coolant
reservoir hose to the frame with
a plastic locking tie and cut off
the tie end.
´ Fasten the wire harness to the
frame at its white tape with a
plastic locking tie and cut off the
tie end.