ƒ Fasten the wire harness, TPS
lead (in the wire harness),
starter motor lead and negative
battery lead to the frame with a
plastic locking tie and cut off the
tie end.
© Make sure that the TPS coupler
does not go out the chassis.
˙ Fasten the TPS lead to the
frame with a plastic band.
ˆ Fasten the neutral switch lead
and oil hose together with the
plastic locking ties and cut off
the tie ends.
∆ Pass the cylinder head breather
hose through the hose holders.
CABLE ROUTING DIAGRAM
˚ Fasten the neutral switch lead
to the frame with a plastic band
ends outward.
¬ Fasten the neutral switch lead
and AC magneto lead to the
frame with a plastic band ends
outward.
µ Pass the cylinder head breather
hose on the outside of the radia-
tor hose 1 and on the inside of the
radiator pipe (radiator hose 4).
˜ Pass the oil tank breather hose
on the outside of the AC mag-
neto lead, neutral switch lead,
wire harness and cylinder head
breather hose.
10
SPEC
ø Pass the wire harness on the
outside of the neutral switch
lead and AC magneto lead.
π Fit the brake hose into the
guides on the protector.
œ Pass the wire harness through
the cable guide.
® Fasten the AC magneto lead
and neutral switch lead to the
cable guide at their protecting
tube with a plastic locking tie
and cut off the tie end.
ß Pass the carburetor breather
hoses,
overflow
hose
coolant reservoir tank breather
hose so that the hoses do not
contact the rear shock absorber.
and