Comfort Glow CS26NT Owner's Operation And Installation Manual page 13

Vent-free freestanding pedestal stove system
Table of Contents

Advertisement

INSTALLATION
Continued
10. Using four screws from hardware bag, mount
blower assembly to stove by attaching
blower brackets to stove top panel (see Fig-
ure 16, page 12). Tighten screws securely.
11. Working from the inside of the stove, insert
shaft of speed control housing into hole on
right side of stove next to the control knob/
piezo ignitor (see Figure 17). Place retainer
nut onto shaft by turning in a clockwise di-
rection until snug. Install plastic control knob
onto output shaft of speed control housing.
12. Check to make sure that the power cord is
completely clear of blower wheel and there
are no foreign objects in blower wheel.
13. Carefully replace stove top panel. Align holes
and replace six screws removed in step 1,
page 12.
14. Peel off the backing paper and stick the sup-
plied wiring diagram decal on the stove floor
as shown in Figure 17.
15. Plug power cord into a convenient 3-prong
grounded wall receptacle near the stove.
WARNING: Electrical Ground-
ing Instructions: This appliance
is equipped with a three-prong
(grounding) plug for your protec-
tion against shock hazard and
should be plugged directly into a
properly grounded three-prong
receptacle.
16. Using speed control knob, turn blower on and
check for operation.
17. All remaining parts from blower kit may be
discarded.
113066-01A
Control
Knob
is plugged in, operating, or hot. Burns and electrical
shock could result. Only a qualified service person
should service or repair heater.
If any of the original wire as supplied with the appliance must be
replaced, it must be replaced with 105°C wire or it's equivalent.
tion when servicing controls. Wiring errors can
cause improper and dangerous operation. Verify
proper operation after servicing.
120 Vac.
60 Hz. .
78 Amps
DESA Heating Products, Bowling Green, KY
Figure 17 - Installing Blower Control
www.desatech.com
Speed
Control
Retainer
Housing
Nut
WARNING: Never attempt to service heater while it
WARNING: Label all wires prior to disconnec-
Variable
Fan Switch
Off
On
110/115
V.A.C.
Black
Green
White
Wiring Diagram Decal
Housing
Power Cord
Blower
Motor
Black
White
13

Advertisement

Table of Contents
loading

Table of Contents