Table of Contents
Advertisement
INSTALLATION
Continued
IMPORTANT: Make sure log does not cover any
burner ports (see Figure 12).
Burner Ports
Figure 12 - Installing One-Piece Log set
(Top View)
INSTALLING BLOWER ACCESSORY
GA3750
Tools required: Phillips screwdriver
NOTICE: Shut off gas heater
during the following blower
installation.
1. Remove top panel of stove by removing six
screws - four from back and one from each
side (see Figure 13).
2. Disconnect power cord wires from blower
motor (if connected) (see Figure 14).
3. Disconnect green ground wire from blower
housing (if connected) by removing screw
holding wire terminal (see Figure 14).
4. Install one plastic bushing provided in blower
1
kit into the 1
/
" hole in the left rear of fire-
2
box floor. Access hole through the rectangu-
lar opening in the rear panel (see Figure 15).
5. Attach the two mounting brackets that were
packaged with the owner's manual to blower
housing using four screws provided in blower
kit (2 for each bracket) (see Figure 16). Tighten
screws securely.
6. Working from the rear of the stove, place en-
tire power cord, including speed control hous-
ing, in lower control compartment.
7. Route ends of 3-wire power cord up from the
lower control compartment through the plas-
tic bushing, then up to the upper cavity of stove
(see Figure 17, page 13).
8. Attach the terminal ends of the white and black
power cord wires to the terminals on the
blower motor (see Figure 14). Push firmly.
9. Attach the terminal end of the green power
cord wire to the front tab of the blower hous-
ing using screw provided (see Figure 14).
12
One Piece
Log Set
White
Powercord
Wire
Figure 14 - Removing Wires from Blower
Blower
Bracket
Figure 16 - Attaching Blower and Blower
www.desatech.com
Figure 13 - Removing Stove Top Panel
Black Powercord Wire
Screw
Green Ground Wire
Figure 15 - Installing Bushing
Brackets to Stove Top
Bushing
Top of
Stove
Blower
113066-01A
Advertisement
Table of Contents
