Getting Started; Connecting The Cradle Unit To The Host Computer System - Panmobil SCANNDY User Manual

5.

GETTING STARTED

5.1 CONNECTING THE CRADLE UNIT TO THE HOST COMPUTER SYSTEM

1. Power OFF your computer system
2. Plug the power supply connector into the power jack of the cradle
3. Plug the interface cable into the connector of the cradle
4. Connect the interface cable to the corresponding interface on your computer system
5. Plug the power supply to your wall plug socket to power ON the cradle unit. You will hear
a beep melody and the power indicator LED will indicate green light
6. Power ON your computer system
Gun Type
Cradle Unit
The cradle unit is now ready to operate.
Before start working with the SCANNDY unit please charge the battery for at least 8 hours to
make sure the battery is fully charged and provides it's best performance.
To charge the battery, place the SCANNDYgun type unit into the gun cradles slot.
As soon as the battery starts charging, the power LED indicates red light. When the battery is
fully charged, the red LED indicator switches OFF automatically.
NOTE:
When charging the battery for the first time, please keep the SCANNDY unit into the cradle for
min. 8 hours even if the red LED indicator already switched off, to make sure the battery is
running on it's best performance!
It is important to consider the surrounding temperature whenever you are charging the Li-
Ion battery pack. The process is most essential that you charge batteries within the stated
range of 8°C to 45°C. Charging batteries outside of the specified range could damage the
batteries and shorten their life cycle.
DC 6V 1.5A
Power Supply
RS232, KBW, Ethernet
or USB Cable
COMPUTER
System
SCANNDY USER GUIDE
Page 10