Connecting To The Mains Supply - Breville MW4 Instructions For Use Manual

MW4.book Page 31 Tuesday, May 16, 2006 4:19 PM

CONNECTING TO THE MAINS SUPPLY

When using electrical appliances, basic safety precautions should
always be followed
WARNING! This appliance must be earthed.
If this appliance is fitted with a rewirable BS1363/A, 13 amp plug, the fuse
should be rated at 13 amps and be ASTA approved to BS1362. However, if
the plug is unsuitable, it should be dismantled and removed from the supply
cord and an appropriate plug fitted as detailed below.
If this appliance is fitted with a moulded BS1363/A 13 amp plug, the fuse
should be rated at 13 amps and be ASTA approved to BS1362. If the fuse
in a non-rewirable plug needs to be changed, the fuse cover must be
refitted. The appliance must not be used without the fuse cover fitted.
In the event of the plug being unsuitable, it should be changed and an
appropriate plug fitted as detailed below. If you remove the plug it must not
be connected to a 13 amp socket and the plug must be disposed of
immediately.
As the colours of the wires in the mains lead of this appliance may not
correspond with the coloured markings identifying the terminals in your plug,
proceed as follows:
The wires of the mains lead are coloured in accordance with the following
code: BLUE = NEUTRAL, BROWN = LIVE, GREEN/YELLOW - EARTH
The wire which is coloured BLUE must
be connected to the terminal in your plug
which is marked with the letter N or
coloured BLACK.
The wire which is coloured BROWN
must be connected to the terminal in your
plug which is marked with the letter L or
coloured RED.
The wire which is coloured GREEN and
YELLOW must be connected to the
terminal in your plug which is marked
with either the letter E or with the earth
symbol, .
If any other plug is used, a 13 amp fuse must be fitted either in the plug or
adaptor or at the distributor board.
.
31
Fit a BS1363/A approved plug
Connect
Green/Yellow
to E (earth)
Connect
Blue to N
(neutral)
Make sure that the outer sheath of the
cable is firmly held by the clamp
Fit a
13 amp
fuse
Connect
Live to L
(live)