Power Connection; Power-On Test; Step 2: Install The Modem Driver - Multitech MT5600BA Quick Start Manual

Power Connection

Plug the transformer module into an AC power outlet or power
strip. Plug the transformer module's cable into the POWER
jack on the modem.
Note: Use only the transformer module supplied with the
modem. Use of any other module voids the warranty and can
damage the modem.

Power-On Test

Test the modem by turning it on (a power switch is located on
the front panel). When you apply power, the modem performs
a diagnostic self-test, indicated by the TM indicator lighting
for a few seconds, after which the LCD should light. If this
does not happen, check that the power switch is on, the trans-
former module supply is solidly connected, and the AC outlet
is live. If these measures do not work, see Chapter 8 of the
User Guide, "Solving Problems."

Step 2: Install the Modem Driver

If you use Windows 95, Windows 98, Windows Me, Windows
NT 4.0, or Windows 2000, you must install the modem driver.
(If you use Windows 3.1 or another operating system, skip this
step and go to Step 3.)
1. Make sure your modem is connected properly, and then
turn on your computer. Windows should detect your new
modem and open the Install New Modem wizard.
Note: If Windows cannot find a modem, your modem may
be turned off, it may be plugged into the wrong connector
on your computer, or the serial cable may be faulty. See
"None of the LEDs Light When the Modem Is Turned On"
and "The Modem Does Not Respond to Commands" in
Chapter 5 of the User Guide, "Solving Problems."
MultiModemII Quick Start Guide
5