Electrical Connections - IDEAL VOGUE s15 Installation And Servicing

24 ELECTRICAL CONNECTIONs

Warning. This appliance MUST be earthed.
A mains supply of 230Vac ~ 50 Hz is required.
The fuse rating should be 3A. All external controls and wiring
must be suitable for mains voltage.
Wiring external to the boiler MUST be in accordance with the
current I.E.E. (BS.7671) Wiring Regulations and any local
regulations.
25 MAINs WIRINg
The Ideal Vogue System Boiler mains input must be
connected to a permanent live supply and NOT
switched by thermostats/programmers. To connect the
mains input proceed as follows.
Wiring should comply with the notes in Page 9.
1. Isolate the mains supply to the boiler.
2. Remove the front panel (refer to Frame 8).
3. Swing the control box down into the service position
(refer to Frame 46).
4. Loosen the cable clamp.
vogue system boiler -
INSTALLATION
6
Installation and Servicing
Wiring should be 3 core PVC insulated cable, not less than
0.75mm 2 (24 x 0.2mm), and to BS 6500 Table 16. For IE
reference should be made to the current ETCI rules for
electrical installations.
Connection must be made in a way that allows complete
isolation of the electrical supply such as a double pole switch
having a 3mm (1/8") contact separation in both poles. The
means of isolation must be accessible to the user after
installation.
6. Route the cable back through the cable clamp and grommet and
re-tighten to provide cord anchorage.
7. Connect the Live, Neutral and Earth wires to the terminal strip.
When making the mains electrical connections to the boiler it
is important that the wires are prepared in such a way that the
earth conductor is longer than the current carrying conductors,
such that if the cord anchorage should slip, the current carrying
conductors become taut before the earthing conductor.
8. Swing the control box back up into the operating position and re-
fit the front panel ensuring a good seal.
4
L N E
27