Canon EOS Rebel XT Instruction Manual page 154

Troubleshooting Guide
If there is a problem, first refer to this Troubleshooting Guide. If this
Troubleshooting Guide does not resolve the problem, contact your
dealer or nearest Canon Service Center.
Power Source
The battery cannot be recharged.
<iii
You are using the wrong battery.
~
Use Battery Pack NB-2LH.
ill!
The battery pack is not properly attached to the battery charger.
ilJv
Attach the battery pack properly to the charger. (p.20)
The camera does not operate even when the power switch is set to
<ON>.
~
The battery is exhausted.
~
Recharge the battery pack. (p.20)
%}
The battery is not installed properly.
!>
Install the battery properly. (p.22)
@l
Battery compartment cover is not closed.
~
Close the battery compartment cover securely. (p.22)
@
CF card slot cover is not closed.
l' F
Close the CF card slot cover securely. (p.26)
The access lamp still blinks even when the power switch is set to
<OFF>.
If you set the power switch to
<OFF>
right after shooting, the
access lamp will still light/blink for a few seconds until the
camera finishes recording the image onto the CF card.
When the camera finishes recording the image to the CF card, the
access lamp will stop blinking and the power will turn off
automatically.
The battery becomes exhausted quickly.
@>
The battery is not fully charged.
IP
Recharge the battery fully. (p.20)
<ill
The battery's service life has expired.
i J l >
Replace the battery pack with a new one.
154