Canon EOS Rebel XT Instruction Manual page 54

Ii!iI3mJ
Setting the Image-recording Quality
Max.
Burst Durlng Continuous
Shooting
The maximum burst during continuous shooting depends on the image-
recording quality. The approx. maximum burst during continuous
shooting is indicated below for each image-recording quality.
Note that with high-speed CF cards, the maximum burst may be higher
than shown in the table below depending on the shooting conditions.
The number of shots remaining during
the maximum burst is displayed on the
lower right of the viewfinder.
Max. Burst
110
80 780
5 4
If "9" is displayed, it indicates that the maximum burst is nine or more
shots. If "5" is displayed, it is five shots.
@)
While you are shooting and the remaining maximum burst is fewer
than 9, the viewfinder will display "8", "7", etc. If you stop the
continuous shooting, the maximum burst will increase.
The maximum burst may greatly decrease in the following cases:
• In the
<~l>
mode, the built-in flash automatically switches between
firing and non-firing as you shoot continuously.
• During continuous shooting, the external flash cannot recycle fast enough.
The following operations will also greatly decrease the maximum burst:
• Pressing the shutter button completely repeatedly at short intervals.
• Right after taking a picture, you change the shooting mode and take pictures immediately.
• During continuous shooting, you pop-up or retract the built-in flash or
turn the external Speedlite on or off.
The above table's figures for the maximum burst apply when all the
captured images have been processed internally and written to the CF card.
With white balance bracketing (p.60), the maximum burst will be 2 shots.
The maximum burst is displayed even when the drive mode is set to <0> (Single) or
<
~ >.
The maximum burst is displayed even when a CF card is not in the camera.
Therefore, before shooting, make sure that a CF card is installed in the camera.
54