Installing Memory - Supero SUPERSERVER 6016TT-TF User Manual

5-6

Installing Memory

CAUTION! Exercise extreme care when installing or removing
!
DIMM modules to prevent any possible damage.
Memory Support
Each X8DTT-F/X8DTT-IBXF/X8DTT-IBQF has six 240-pin DIMM slots that can
support up to 48 GB of registered ECC DDR3-1333/1066/800 SDRAM (for a total
of 96 GB in the system) or up to 24 GB of ECC unbuffered DDR3-1333/1066/800
SDRAM (for a total of 48 GB in the system).
Note: Check the Supermicro web site for recommended DIMMs.
Installing Memory Modules
1. Insert each memory module vertically into a slot following the charts below.
Pay attention to the notch along the bottom of the module to prevent inserting
it incorrectly.
2. Gently press down on the DIMM module until it snaps into place in the slot
(see Figure 5-3).
Populating Memory for Optimal Performance
Branch 0
3 DIMMs P1 DIMM1A
6 DIMMs P1 DIMM1A
Populating Memory for Optimal Performance
Branch 0
6 DIMMs 1A
12 1A 1B
DIMMs
Chapter 5: Advanced Serverboard Setup
(Single CPU Confi guration)
Branch 1
P1 DIMM2A
P1 DIMM1B P1 DIMM2A
(Dual CPU Confi guration)
CPU1
Branch 1 Branch 3
2A 3A
2A 2B 3A 3B
5-9
Branch 2
P1 DIMM3A
P1 DIMM2B P1 DIMM3A
CPU2
Branch 0 Branch 1
1A 2A
1A 1B 2A 2B
P1 DIMM3B
Branch 3
3A
3A 3B