Rear And Front Panel Overviews - LG PCS200R Pro:Centric Installation And Setup Gude

Rear and Front Panel Overviews

PCS200R Rear View
Disconnect Device
The AC mains plug is used as the disconnect device. The disconnect device
must remain readily operable.
RF OUT (0 dBmV) Connector
Reserved for service technician use only. When not in use, this connector must
remain terminated with attached terminator accessory.
USB Port
Reserved for service technician use only.
PCS200R Front View
Ventilation
Air flow must not be obstructed. To ventilate the system normally and avoid
overheating, leave at least 1 inch (2.5 cm) on each side (including top and bottom)
of the PCS200R. Do NOT stack other equipment on the top of the PCS200R.
Screws with Lock Washers
Only qualified service personnel should handle and install the PCS200R. A series
of screws with lock washers are used to secure the top and bottom covers of the
PCS200R. Use caution when handling the unit as the lock washers may have
rough edges. Do NOT run your fingers over the top and bottom covers of the unit.
10
SSD (OPT IONA L)
MAX IMUM CUR RENT
+5V DC @ 2.0A
RF-OU T
0 dBmV
SSD Slot
RF OUT
RF OUT
(for SATA solid state
(0 dBmV)
drive functionality)
MODEL: PCS200R
DATE: xx/xx/xx
I IIIII IIIIIIII IIIIIIIIIIIIIII
IIIII IIIIIIIIIIIIIII IIIIIII
*201-125 2008*
RF-OU T
ASI-O UT
FIRMW ARE VER: Featu re Port SERV ICE USE ONLY
Cont rol Port
Rx.x
MAC ADDRE SS:
<Eth0> Serv ice Port
xx:xx:xx :xx:xx:x x
<Eth1>
xx:xx:xx :xx:xx:x x
Service Port
ASI OUT
USB Port
(service use
FEATURE
only)
& CONTROL
(Ethernet) Ports
Cord & Adapter
PWR
POWER LED
POW ER
12V
AC Power
206-4227