Rear And Front Panel Overviews; Rack Installation - LG PCS150R Pro:Centric Installation & Setup Manual

Rear and Front Panel Overviews

PCS150R Rear View
Disconnect Device
The AC mains plug is used
as the disconnect device.
The disconnect device must
remain readily operable.
PCS150R Front View
Ventilation Holes
Air flow must not be obstructed.
To ventilate the system normally
and avoid overheating, leave at
least 1 inch (2.5 cm) on each
side (including top and bottom)
of the PCS150R. Do NOT stack
other equipment on the top of
the PCS150R.
8
R F -O
U T
. . . .
. . . . .
A S I-
O U
T
RF Out
RS-232 Port
ASI Out
USB Ports
NETWORK
(Ethernet) Ports
S TA
T U S
STATUS LED
Typical PCS150R

Rack Installation

1. Carefully slide the
chassis into a standard
19-inch equipment
rack.
2. Use all four mounting
screws to secure the
chassis to the rack.
Rack-mount Considerations
A. Elevated Operating Ambient
If installed in a closed or multi-unit rack
assembly, the operating ambient tem-
perature of the rack environment may be
Power
Supply/Cord
greater than room ambient. Therefore,
consideration should be given to install-
ing the equipment in an environment
compatible with the maximum ambient
temperature (Tma) specified by the man-
ufacturer (see Specifications information
in this document).
B. Reduced Air Flow
Installation of the equipment in a rack
should be such that the amount of
air flow required for safe operation of
the equipment is not compromised.
To ventilate the system normally and
avoid overheating, leave at least 1 inch
(2.5 cm) on each side (including top
and bottom) of the PCS150R. Do NOT
stack other equipment on the top of the
PCS150R unit.
206-4191 206-4191
Rack Installation
S TA
T U S
C. Circuit Overloading
Consideration should be given to the
connection of the equipment to the sup-
ply circuit and the effect that overloading
of the circuits might have on overcurrent
protection and supply wiring.
D. Reliable Earthing
Maintain reliable earthing of rack-
mounted equipment. Particular attention
should be given to supply connections
other than direct connections to the
branch circuit (e.g. use of power strips).
E. Mains Outlet Earthing
The apparatus with Class I construction
must be connected to a mains socket
outlet with a protective earthing connec-
tion.
9