Universal Garage Door Opener - Jeep 2010 Liberty User Manual

• Press and release the Compass/Temperature
Compass/Temperature screens.
• Press the RESET

UNIVERSAL GARAGE DOOR OPENER

• Place the hand-held transmitter 1 to 3 in (3 to 8 cm) from the HomeLink® buttons while
keeping the indicator light in view.
• Simultaneously, press and hold both the chosen HomeLink® button and the hand-held
transmitter button until the HomeLink® indicator flash rate changes from a slow to a
rapidly blinking light, then release both the HomeLink® and the hand-held transmitter
buttons. This may take up to 30 seconds, or longer in rare cases.
• Press and hold the just-trained HomeLink® button; if the indicator light stays on
constantly, programming is complete and the garage door should open.
• Your motorized door or gate will open and close while you are training the
universal transceiver. Do not train the transceiver if people or pets are in the path
of the door or gate. Only use this transceiver with a garage door opener that has a
"stop and reverse" feature as required by Federal safety standards. This includes
most garage door opener models manufactured after 1982. Do not use a garage
door opener without these safety features. Call toll-free 1–800–355–3515 or, on
the Internet, at www.HomeLink.com for safety information or assistance.
• Vehicle exhaust contains Carbon Monoxide (CO), a dangerous gas. Do not run your
vehicle in the garage while training the transceiver. Exhaust gas can cause serious
injury or death.
NOTE: If you are having difficulty training your HomeLink® and your garage door opener
was manufactured after 1995, you may have a rolling code. Follow the steps below for
Programming A Rolling Code System.
button to RESET Trip Functions and change Personal Settings.
Programming HomeLink®
Begin Programming
• The HomeLink® buttons are located in the
• Erase all channels before you begin training
• Park your vehicle outside of the garage and
WARNING!
ELECTRONICS
button for instant access to the
sun visor.
by holding the two outside buttons for up to
20 seconds until the red indicator flashes.
turn the ignition switch to the ON/RUN
position.
33