Voice Command - Jeep 2010 Liberty User Manual

ELECTRONICS
Mute (Or Unmute) Microphone During Call
• During a call, press the Voice Command button
• (After the BEEP), say "mute on" (or "mute off").
Transfer Ongoing Call Between Handset And Vehicle
• During a call, press the Voice Command button
• (After the BEEP), say "transfer call".
Changing The Volume
• Start a dialogue by pressing the Phone button
normal call.
• Use the radio ON/OFF VOLUME rotary knob to adjust the volume to a comfortable level
while the Uconnect™ system is speaking. Please note the volume setting for Uconnect™
is different than the audio system.
NOTE: To access the tutorial, press the Uconnect™ hard-key. After the BEEP, say
"tutorial". Press any hard-key or touch the display to cancel the tutorial.

VOICE COMMAND

• The Voice Command system allows you to control your AM, FM radio, satellite radio, disc
player, and a memo recorder. When you press the Voice Command button
will hear a beep. The beep is your signal to give a command. If you do not say a
command within a few seconds, the system will present you with a list of options. If you
ever wish to interrupt the system while it lists options, press the Voice Command
button , listen for the BEEP, and say your command.
• For vehicles equipped with Video Entertainment System (VES)™, refer to the Voice
Command section of the Uconnect™ User's Manual on the DVD for further details.
• For vehicles not equipped with VES™, refer to your vehicle Owner's Manual on the DVD
for Voice Command information.
Changing The Volume
• Start a dialogue by pressing the Voice Command button
(e.g., "tutorial").
• Use the radio ON/OFF VOLUME rotary knob to adjust the volume to a comfortable level
while the Voice Command system is speaking. Please note the volume setting for Voice
Command is different than the audio system.
Any voice commanded system should be used only in safe driving conditions and all
attention should be kept on the roadway ahead. Failure to do so may result in an
accident causing serious injury or death.
NOTE: To access the tutorial, press the Voice Command button
say "tutorial". Press any hard-key or touch the display to cancel the tutorial.
.
.
, then adjust the volume during a
WARNING!
36
, you
, then say a command
. After the BEEP,