Jack Location; Spare Tire Stowage; Preparations For Jacking - Jeep 2010 Liberty User Manual

Hide thumbs Also See for 2010 Liberty:
Table of Contents

Advertisement

WHAT TO DO IN EMERGENCIES

Jack Location

Spare Tire Stowage

• To remove the spare tire, remove the jack-handle components from the storage bin in the
left rear trim panel and assemble them.
• Lower the spare tire by turning the winch drive nut, located in the rear cargo area inside
the vehicle, counterclockwise with the jack-handle assembly until the spare tire is on the
ground with enough cable slack to allow you to pull the spare tire out from underneath
the vehicle.
• When the spare is clear, tilt the retainer at the end of the cable and pull it through the
center of the wheel.

Preparations For Jacking

• Park on a firm, level surface. Avoid ice or slippery areas.
• Set the parking brake and shift the automatic transmission into PARK.
• Turn the ignition to LOCK and turn on the Hazard Warning flasher.
• The scissor-type jack and tire changing tools
are located in the left rear trim panel behind
the second row seat.
• Block both the front and rear of the wheel
diagonally opposite of the jacking position.
For example, if changing the right front tire,
block the left rear wheel.
NOTE: Passengers should not remain in the
vehicle when the vehicle is being jacked.
48

Advertisement

Table of Contents
loading

Table of Contents