Universal Garage Door Opener; (Homelink®) - If Equipped; Before You Begin Programming; Homelink - Jeep CHEROKEE 2021 Owner's Manual

76 GETTING TO KNOW YOUR VEHICLE

UNIVERSAL GARAGE DOOR OPENER

(HOMELINK®) — IF EQUIPPED
HomeLink® Buttons On Sun Visor
HomeLink® replaces up to three hand-held

transmitters that operate devices such as garage
door openers, motorized gates, lighting, or home
security systems. The HomeLink® unit is
powered by your vehicles 12 Volt battery.
The HomeLink® buttons that are located in

the overhead console or sunvisor designate
the three different HomeLink® channels.
To operate HomeLink®, push and release

any of the programmed HomeLink® buttons.
These buttons will activate the devices they
are programmed to with each press of the
corresponding HomeLink® button.
The HomeLink® indicator light is located

above the center button.
The HomeLink® buttons, located on the driver's
side sun visor, designate the three different
HomeLink® channels. The HomeLink®
indicator is located above the center button.
NOTE:
HomeLink® is disabled when the Vehicle Secu-
rity system is active.
B Y B P
EFORE OU EGIN ROGRAMMING
H L ®
OME INK
For efficient programming and accurate
transmission of the radio-frequency signal, it is
recommended that a new battery be placed in
the hand-held transmitter of the device that is
being programmed to the HomeLink® system.
Make sure your hand-held transmitter is
programmed to activate the device you are
trying to program your HomeLink® button to.
Ensure that your vehicle is parked outside of the
garage before you begin programming.
It is recommended that you erase all the
channels of your HomeLink® before you use it
for the first time.
E A T H L
RASING LL HE OME
C
HANNELS
To erase the channels, follow this procedure:
1. Place the ignition switch into the ON/RUN
position.
2. Push and hold the two outside HomeLink®
buttons (I and III) for up to 20 seconds, or
until the HomeLink® indicator light flashes.
NOTE:
Erasing all channels should only be performed
when programming HomeLink® for the first
time. Do not erase channels when programming
additional buttons.
®
INK