Hi Power Operation; Timer Operation - Toshiba RAV-SM561KRT-E Owner's Manual

Hi POWER OPERATION

High power (Hi POWER)
• The Hi POWER (high power operation) mode automatically controls
room temperature, air flow and operation mode so that the room is
quickly cooled in summer and warmed in winter. (
Setting Hi POWER mode
1 1 Hi POWER button 1
1 1
Press the HI POWER button after starting any operation. At the same
time, the "Hi POWER" mark on the remote control is indicated.
Canceling Hi POWER mode
1 1 1 Hi POWER button
1 1
Press the Hi POWER button once again.
At the same time, the "Hi POWER" mark on the remote control goes out.
CAUTION
• The Hi POWER mode cannot be activated in the DRY and FAN ONLY operation
and when the ON TIMER operation is reserved.
• Hi-Power mode is not available for twin and group combination. (
When Hi-Power is transmitted to the main unit, the receiving sound is heard
but the Hi-Power mode will not be performed. Please cancel the Hi-Power mode.

TIMER OPERATION

ON timer and OFF timer
Setting TIMER
1 1 1 1 ON/OFF TIMER button 1
Press the ON or OFF TIMER buttons as required.
• The previous timer setting is displayed and flashes along with
ON/OFF TIMER display.
2 2 2 TIMER 2 2
button
Press the TIMER
Set the timer to the desired time.
Each press of the TIMER button changes the time in ten minute steps.
Pressing the TIMER button continually changes the time in one hour step.
3 3 3 SET
3 3
button
SET
Press the SET
SET
The timer time is indicated and the timer starts.
Canceling TIMER
4 4 4 4 4 CLR
button
CLR
Press the CLR
CLR
CAUTION
• When you select the timer operation, the remote control automatically
transmits the timer signal to the indoor unit at the specified time.
Therefore, keep the remote control in a location where it can transmit
the signal to the indoor unit properly.
• If you do not press the SET
the time, the setting will be cancelled.
Once you select the timer operation mode, the settings are saved in the remote control.
Thereafter, the air conditioner will start operating under the same conditions when you simply press the ON/OFF button
of the remote control.
If the clock display is flashing, you cannot set the timer.
Follow the instructions in the section "SETTING THE CLOCK" on page 6 to set the clock, and then set the timer.
3
button.
button to set the timer.
button to cancel the timer setting.
button within 30 seconds after setting
SET
see page 22.)
see page 7.)
11
A
START/STOP
FAN MODE
ECO
SWING
1
TIMER
FIX
ON OFF
FILTER
START/STOP
FAN MODE
SWING ECO
1
TIMER
FIX
ON OFF
2
FILTER
3
4
PRESET
AUTO
Hi-POWER
MEMO
SET CLR
RESET CLOCK CHECK
PRESET
AUTO
Hi-POWER
MEMO
SET CLR
RESET CLOCK CHECK
EN