Remote Control; Power-Selection Operation; Automatic Operation; Hi-Power Operation - Toshiba RAS-18PACVG -T Owner's Manual

4

REMOTE CONTROL

Note:
● The provided Remote Controller is a wireless type, which also can be
used as a wire. Please see "How to Connect The Remote Controller
for Wired Operation", located in installation instruction, in case of wired
control is required.
● In wire operation, remote controller will return to initial condition (PRESET,
TIMER and CLOCK will return to initial condition) when user shutdown
power supply of Air conditioner.
5

AUTOMATIC OPERATION

To automatically select cooling or fan only operation
MODE
1. Press : Select A.
2. Press : Set the desired temperature.
6 COOLING / FAN ONLY OPERATION
MODE
1. Press : Select Cool or Fan only
2. Press : Set the desired temperature.
Cooling: Min. 17°C, Fan Only: No temperature indication
7 DRY OPERATION
For dehumidifi cation, a moderate cooling performance is controlled automatically.
MODE
1. Press : Select Dry .
2. Press : Set the desired temperature.
8

Hi-POWER OPERATION

To automatically control room temperature and airfl ow for faster cooling
operation (except in DRY and FAN ONLY mode)
Hi POWER
Press : Start and stop the operation.
9
1
#
4
2
6
3
5
SWING FAN
7
(
AIR FLOW
$ FIX FIX
%
&
POWER-SEL Hi POWER
"
COMFORT
10
8 9
SLEEP
!
)
,
-
+ ~
11
.

POWER-SELECTION OPERATION

This function is used when its circuit breaker is shared with other electrical
appliances. It limits the maximum current/power consumption to 100%, 75%
or 50%. The lower the percentage, the higher the saving and also the longer
the compressor lifetime.
POWER-SEL
Press : Select (for 100%),
● When the level is selected, PWR-SEL level flashes on LCD display for 3
seconds. In case of 75% and 50% level, number "75" or "50" also flashes
for 2 seconds.
● Due to the reason that POWER SELECT FUNCTION limits the maximum
current, inadequate cooling capacity may occur.
TIMER OPERATION
Set the timer when the air conditioner is operating.
Setting the ON Timer
1 Press : Set the desired
ON timer.
2
Press : Set the timer.
3
Press : Cancel the timer.
Daily timer allows the user to set both the ON & OFF timers and will be
activated on a daily basis.
Setting Daily Timer
1
Press : Set the ON timer.
2
Press : Set the OFF timer.
● During the daily timer is activating, both arrows ( , ) are indicated.
Note:
● Keep the remote control in accessible transmission to the indoor unit;
otherwise, the time lag of up to 15 minutes will occur.
● The setting will be saved for the next same operation.
DISPLAY LAMP BRIGHTNESS ADJUSTMENT
To decrease the display lamp brightness or turn it off.
FAN
1. Press and hold for 3 seconds until brightness level (
or ) is shown on remote control LCD then release the button.
2. Press or
Rise
Decrease
Remote control
Operation display
LCD
Lamp illuminates full brightness.
Lamp illuminates 50% brightness.
Lamp illuminates 50% brightness and the operation lamp
is turned off.
All lamps are turned off.
● In the examples of
and , the lamp illuminates for 5 seconds before
going off.
(for 75%), (for 50%)
EN
Setting the OFF Timer
Press : Set the desired
OFF timer.
Press : Set the timer.
Press : Cancel the timer.
3
Press .
Press button during
4
the ( or ) mark fl ashing.
, ,
to adjust brightness in 4 levels.
Brightness
100%
50%
50%
All turned off