Correct Usage - Toshiba RAV-SM561KRT-E Owner's Manual

CORRECT USAGE

When you use the air conditioner for the first time or when you change the SET DATA value, follow the procedure below.
From the next time, the operation displayed on the remote controller will start by pushing the
Preparation
Turn on the main power switch and/or the leakage breaker.
• When the power supply is turned on, a partition line is displayed on the display part of the remote controller.
* After the power supply is turned on, the remote controller does not accept an operation for approx. 1 minute, but it is
not a failure. ( lamp lights up at this time.)
REQUIREMENT
• While using the air conditioner, operate it only with
and the leak breaker.
3
1 1 Push 1
1 1
The operation lamp goes on, and the operation starts.
2 Select an operation mode with the "MODE" 2 2
2 2
button.
One push of the button, and the display changes in the
order shown on the right.
• In HEAT
mode, if the room temperature reaches to the set temperature, the outdoor unit stops and the air
flow becomes LOW and the air volume decreases.
• In the defrost mode, the fan stops so that cool air is not discharged and STAND BY
controller and main unit).
3 3 3 Select air volume with "FAN 3 3
One push of the button, and the display changes in the
order shown on the right.
• When air volume is "AUTO
• In DRY
mode, "AUTO
• In heating operation, if the room temperature is not heated sufficiently with VOLUME "LOW
"MED " or "HIGH
4 4
4 4 4 Determine the set up temperature by pushing the "TEMP.
Stop
Push button.
The operation lamp goes off, and the operation stops.
button.
" button.
", air volume differs according to the room temperature.
" is displayed and the air volume is LOW.
" operation.
button without turning off the main power switch
UNIT
SET CL
AUTO
17
1
2
4
HEAT DRY
is displayed (remote
AUTO HIGH
" or "TEMP.
3
button only.
COOL FAN
MED. LOW
" operation, select
" button.
EN