®
Invacare
- FDX
8.13.2 Replacing the tilt module / lifter module
8.13.2.1 Replacing the tilt module (without lifter)
Note
This chapter describes how to replace the tilt module on a wheelchair without a lifter.
Similar tasks are described In the following chapters:
● Replacing the seat frame alone – chapter 8.13.1
● Replacing a lifter / tilt module – chapter 8.13.2.2
● Replacing just the tilt actuator – chapter 8.13.2.3
● Replacing just the lifter actuator – chapter 8.13.2.4
WARNING: Danger of crushing!
The seat is very heavy. Danger of injury to hands and feet!
● Use proper lifting techniques.
Requirements:
● 13 mm open-ended wrench
● 4 mm Allen key
● 6 mm Allen key
● Side cutting pliers
● Cable ties
Note
Take careful note of the exact position of the seat. Mark the position it is mounted in, the angle
and so on. If necessary, make photographs with a digital camera.
Any modification of the adjustment of the seat affects the centre of gravity of the wheelchair.
Uninstalling the tilt module:
●
If possible, tip the wheelchair with the tilt module as far backwards as it will go.
●
Switch the electronic control system off.
The actuator module for the lifter and the tilt actuator are mounted to the front edge of the seat
frame.
SERVICE MANUAL
101