SERVICE MANUAL
8.6.9
Replacing the front bulb holder (LED lighting system until 03/2012)
Requirements:
● 4 mm Allen key
● 8 mm spanner
Dismantling the bulbholder:
●
Loosen the Allen screw (1) using a 4 mm Allen key and remove the headlight from the
mounting.
●
Loosen the two cap nuts (2) using an 8 mm spanner and remove the headlight with the
mounting from the rubber bumpers.
●
Replace the mounting.
Refitting the bulbholder:
●
Refit the parts in reverse order.
●
Now tighten all the screws finger-tight again.
●
Check all vehicle functions.
●
Adjust the headlight roughly using the grid. The user can carry out the final adjustment
following the operating manual.
70
®
Invacare
- FDX