Replacing The Lifter / Seat Angle Adjustment Module - Invacare FDX Service Manual

®
Invacare - FDX

8.17.4 Replacing the lifter / seat angle adjustment module

Note
Replacement of the seat angle adjustment module is performed in the same manner.
ATTENTION: Danger of crushing!
The seat/seat frame is very heavy. Danger of injury to hands and feet!
● Use proper lifting techniques
Requirements:
● 3 mm Allen key
● 5 mm Allen key
● T25 Torx wrench
● T40 Torx wrench
● Side cutting pliers
● Cable ties
● Remove legrests.
● Tilt the seat tilting completely to the rear if
possible.
● Switch the electronics OFF on the remote.
● Remove the backrest cushion.
● Loosen and remove the screws, which secure
the middle seat plate (A) with a 3 mm Allen key.
● Remove the middle seat plate (B).
● Loosen and remove the screws on both sides,
which secure the lateral seat plates (C) with a
3 mm Allen key.
● Remove the lateral seat plates (D).
or
● Remove the seat cushion.
● Loosen and remove the screws on both sides,
which secure the sling seat (A) with a
T25 Torx wrench.
● Remove the sling seat (B).
SERVICE MANUAL
151