Advertisement
INTRODUCTION
The DOL1000-MF is a versatile keypad that has the option of running wirelessly. The DOL1000-MF
can work with 6 volts of battery power or 6-24 volts of AC/DC. This keypad can be wired with multiple
wireless transmitters. DOL1000-MF can store up to 1000 access codes. Guest access codes are also
programmable, which are single-use codes for access. After 5 successive incorrect codes, the
keypad will lock for 4 minutes
1 2 3 4, 1#, Access Code: __ __ __ __ , Channel:1-4, #
Add Access
Use Channel 1 if unsure. The different channels are dependent on the RF
Codes
terminal used. Any channel can be assigned for devices that connect to normally
open/normally closed.
1 2 3 4, 2#, Access Code: __ __ __ __ , #
Remove Access
Codes
Enter the Access Code you would like to delete.
1 2 3 4, 3#, Guest Code: __ __ __ __ , Channel:1-4
Add Guest
Code
The Guest Code is a one-time use access code. Once used, the number will be
cleared from memory.
1 2 3 4, 4#, Toggle Code: __ __ __ __ , Channel:1-4
Add Access
Entering Access Toggle Code will toggle the keypad to continuously activate.
Toggle Code
Entering the code again will toggle the keypad off. Dip switch #6 on the circuit
board needs to be in the off position in order for this mode to work.
1 2 3 4, 5#, Seconds:0-60, #
Set Relay
Output Time
Set the number of seconds the device will grant access before locking again.
1 2 3 4, 7#, Master Code: __ __ __ __ , #
Change Master
Code
Changes Master Code. If the Master Code is forgotten, this manual contains
instructions on how to reset the Master Code.
1 2 3 4, 8#
Clear All Codes
This will clear all data except the Master Code.
To clear an entry, press *
PROGRAMMING CHART: DOL1000-MF
Default Master Code: 1 2 3 4
Advertisement
