Straight Stitches And Needle Position; Zigzag Stitches - Bernina Bernette 20 Instruction Manual

Straight Stitches and Needle Position

0.0 2.0 3.5
0.5 1.0 2.0

Zigzag Stitches

0.0 1.0 3.0
0.5 1.0 2.0
5.0 7.0
3.0 4.5
5.0 7.0
3.0 4.5
Basic Sewing Procedures
Changing the needle position
These setting apply only to pattern 01-03, 24.
The pre-set position is "3.5", center position.
Press the stitch width button to enter stitch
width adjustment mode. When you turn the
selector wheel counter clockwise, the needle
position will move to the left. When you turn
the selector wheel clockwise, the needle
position will move to the right.
Changing the stitch length
Press the stitch length button to enter stitch
length adjustment mode.
To shorten the stitch length, turn the
wheel counter clockwise. For a longer stitch
length, turn the selector wheel
Generally speaking, the thicker the fabric,
thread and needle, the longer the stitch
should be.
Adjusting the stitch width
The maximum zigzag stitch width for zigzag
stitching is "7.0"; however, the width can be
reduced on any patterns.
Press the stitch width button to enter stitch
width adjustment mode, he stitch width can
be adjusted between "0.0-7.0 mm".
Adjusting the stitch length
The density of zigzag stitches increase as
the setting of stitch length approaches "0.3".
Neat zigzag stitches are usually achieved at
"1.0-2.5". Closed up zigzag stitches (close
together) are referred to as a satin stitch.
selector
clockwise.
t
37