Table of Contents
Advertisement
MISCELLANEOUS
Frame Skip
To lower the frame rate (and bandwidth), increase this value. A value
of 0 means full frame rate, a value of 1 means skip every other frame, a
value of 2 means skip every two frames, etc.
LED
The LED indication on the front of the camera can be configured in a
number of different ways:
•
Off - LED is always off. Useful when you do not want the camera
to be seen at night or if you are experiencing a visible reflection in a
window.
•
Green-Yellow Active - LED remains green until image activity
occurs (viewing, recording, FTP, etc.), in which case it momentarily
blinks yellow.
•
Green-Red Motion - LED remains green until internal video motion
is detected, in which case it momentarily blinks red.
•
Green-Red-Yellow - A combination of Green-Yellow Active and
Green-Red-Motion.
Video Out
Controls video out BNC port on the back of the camera. It can be turned
off (no video out) or set to NTSC or PAL. When set to NTSC or PAL, the
camera's video can be viewed with any standard video monitor. Note: the
video resolution will be scaled up or down to the maximum NTSC or PAL
resolution.
IR (only available on IR models)
This determines how the mechanical IR (infrared) filter behaves.
•
Off - The camera will only see visible light.
•
On - The camera will see both visible and infrared light.
•
Auto - The camera will automatically determine what position
the IR filter should be in (IR is normally only needed in low light
situations). If you plan on using the IR mode (on or auto), an IR
illuminator is recommended.
COLOR BALANCE
Auto Color Balance
Enabling Auto Color Balance causes NetCam SC to automatically
adjust the color balance of the image based on the content of the image. In
most situations, you will want Auto Color Balance enabled.
NetCam SC
Page 15
- Quick Links:
- Connecting Netcam Sc to a Network
Hide quick links:
Advertisement
Table of Contents
