StarDot Technologies NetCam SC User Manual page 27

Consult your network administrator to determine which IP address
to use. If you are setting up the camera behind a residential gateway
or cable/DSL router, your IP address will probably be something
similar to 192.168.1.5.
•
Subnet Mask - Find out your netmask from your network
administrator. If you're on a private network, your netmask will
almost always be 255.255.255.0.
•
MAC Address - This is the factory-set Ethernet address of the
camera. It also serves as the Camera ID (serial number). It cannot be
changed.
Network
Hostname
Alphanumeric name of the camera that can get linked to its IP address.
This is disabled if DHCP is enabled.
Default: NetCamSC
Gateway
In most cases, this is a machine name or IP address that serves as a
gateway to the Internet. If the camera is on a private network behind a
router/gateway, you would enter the IP address of the router/gateway. This
is disabled if DHCP is enabled.
Domain Name Servers (DNS)
Domain name server IP address. This is critical if your FTP server and/or
time server is entered as a domain name and not an IP address. Check with
your ISP to determine your name servers (you can list up to three). This is
disabled if DHCP is enabled.
Web Server Port
The default web server port is 80. A situation that calls for changing
the port number is if you're hosting one or more cameras behind a router
that supports port forwarding. This allows you to access multiple cameras
behind a single public IP address.
Example: Assign the camera a web server port of 8085. In your router, under the port
Use caution when changing the web server port number. If it's anything
but 80, you will need to add <:port number> to the end of the IP address
when browsing (example: http://192.168.1.5:8085).
Default: 80
NetCam SC
forwarding section, route port 8085 to the camera's IP address.
Page 27